Brink Climate Systems fault code E106* (Subcode E1300)
Fault code E106* (Subcode E1300) on an Brink Climate Systems MVHR unit (including Flair) means: Sensor NTC1 faulty; general error. Reset the appliance once. If the code comes back, a part is usually faulty, often a temperature sensor. You can check the water pressure and settings yourself; leave work on gas-carrying parts to a certified gas engineer.
After a safety alert (gas, flue gas, combustion), reset no more than once and call in a certified gas engineer. If you smell gas, call your national gas emergency number or 112 immediately.
Cause
Fault code E106* (Subcode E1300) on an Brink Climate Systems MVHR unit indicates: Sensor NTC1 faulty; general error.
Fixing fault code E106* (Subcode E1300): step by step
- Reset the appliance once; a one-off measuring error will then clear.
- Where you can reach it without opening the sealed combustion section, check that the sensor plug is seated firmly and the wiring is undamaged.
- If the code comes back, the sensor or its wiring is usually faulty (short or open circuit). Sensors in the sealed combustion section should be replaced by a qualified heating engineer.
Applies to
Brink Climate Systems Flair, 300, 400.
Matching parts
Brink Climate Systems parts are available from Instalpunt; shipping to EU countries from €12.95 (€16.95 for more distant countries), usually 3–5 working days.
For fault code E106* (Subcode E1300), the part involved is usually in the category: sensor.
Based on the cause, these original Brink Climate Systems parts fit (always check the type number of your appliance):
- Brink temperature sensor € 53.00
All Brink Climate Systems parts →
Further reading on this cause
Other Brink Climate Systems codes with the same cause
- 106 — Outdoor air temperature sensor (lockout fault)
- 107 — Extract air temperature sensor
- 109 — CO2 sensor
- 111 — Humidity sensor
- E100 — Supply fan pressure sensor faulty. Red pressure tubes blocked or kinked.
- E101 — Extract fan pressure sensor faulty. Blue pressure tubes blocked or kinked.
Fix it yourself or call an engineer?
Always consult the manual for your appliance and work safely. If in doubt or if the fault comes back, call in a qualified professional. A question about a part? Write to us at info@instalpunt.nl.
Frequently asked questions
What does Brink Climate Systems MVHR unit fault code E106* (Subcode E1300) mean?
Sensor NTC1 faulty; general error.
How do I fix fault code E106* (Subcode E1300) on an Brink Climate Systems MVHR unit?
First check the cause described above. Then restart the appliance using the reset button. If the message comes back, a part usually needs replacing or the fault needs to be repaired by a qualified professional.
Which parts do I need for Brink Climate Systems fault code E106* (Subcode E1300)?
That depends on the exact cause. In the Brink Climate Systems parts overview at Instalpunt you will find the current price and stock for each part.
Can I fix fault code E106* (Subcode E1300) myself?
You can reset the appliance and check things like the water pressure or settings yourself. Work on gas-carrying parts must be left to a certified gas engineer.
All Brink Climate Systems MVHR unit faults and codes at a glance →