Caldo Trendy ST ceramic fan heater with touch screen and remote
At a glance
A base of 190 by 140 mm is all the floor the Caldo Trendy ST asks for. This ceramic fan heater delivers 1,000 W or 2,000 W and, according to the product sheet, heats a volume of up to 60 m³.
How you use it
There are two ways to operate the heater: tap the touch screen on the appliance, or use the separate remote control from where you are sitting. The room thermostat is adjustable between 15 °C and 30 °C. In Eco Mode the heater adapts its output automatically to the temperature you have asked for; the manufacturer quotes a saving of up to 50% compared with maximum output. A timer of up to 12 hours is provided. The swivel base turns the heater through 80 degrees automatically. Protection comes from a safety thermostat, an overheating cut-out and a tip-over switch. The heater is 450 mm tall, weighs 2.5 kg and runs on a mains supply of 220 to 240 V.
Specifications
| Product code | 99267 |
|---|---|
| Maximum output | 2,000 W |
| Power settings | 1,000 / 2,000 W |
| Heatable volume | Maximum 60 m³ |
| Temperature setting | 15 °C to 30 °C |
| Timer | 12 hours |
| Oscillation angle | 80 degrees |
| Remote control | Yes |
| Protection rating | IPX0 |
| Insulation class | II |
| Power supply | 220/240 V, single phase, 50 Hz |
| Dimensions (w x h x d) | 190 x 450 x 140 mm |
| Weight | 2.5 kg |
Before you buy
- The protection rating is IPX0, which means the heater has no protection against water.
- This model cannot run its fan without heat.
- The saving quoted for Eco Mode is a comparison with running continuously at full output.
Manual and documents
The manufacturer's manual and product sheet are on our specialist site olimpia-air.com (site in Dutch): documents for the Caldo Trendy ST.
Reviews
There are no reviews yet.